Split-type Prepaid Single-phase Smart Meter (DIN Rail Mount)

Split-type Prepaid Single-phase Smart Meter (DIN Rail Mount)

Short Description

CA168-SF43 is our new generation of Din-rail single-phase electricity meter, with accuracy of Class 1,and its shell is made of polycarbonate flame retardant material.This meter is equipped with a current isolation wire and also supports dual circuit measurement and relays to bring outstanding tamper detection features. The communication with the external keypad(ClU) can be done with either PLC, RF, or by Cable connection. Its installation requirements are also optional.

Products Details

Main Features .Multi-Tariff DLMS/COSEM STS prepayment 20 digits STS encryption Tamper detection and record LoraWan centralized collecting Slim-line and space-economy design Disconnect on overload and no credit Programmable load limit and low credit warning Infrared port/RS485/virtual token carrier(optional)Surge protection for lightening and other line surges Up to 13kV/6.5kA surge protection for lightening and other line surges CIU by PLC/RF/ Cable (optional) Split Configuration for Increased Revenue Protection The CIU (Customer Interface Unit) is optional. The MCU (Metering & Control Unit) and CIU is linked via Mbus 2 wires communication, galvanically-isolated PLC or RF wireless communication, the communication method is on request. The CIU is installed within consumer’s home, while MCU is installed in a meter cabinet away from consumers.
Electrical parameters:
Voltage
Nominal voltage Un 230V
Limited voltage 70%~120%Un
Frequency
Nominal frequency fn 50-60Hz
tolerance 5%
Current
Basic current(Ib) 5A
Maximum current(Imax) 60A (100A optional)
Starting current(Ist) 0.4%Ib
Active energy constant 1000imp/kWh
Measurement Accuracy
Active energy to IEC62053-21 Class1.0
Burden
Voltage circuit <2W  <8VA
Current circuit <1VA
Temperature range
Operation meter -25℃ to+70℃
Storage -40℃ to+85℃
Insulation
Insulation level 4kV rms 1min
Voltage impulse withstand 8kV 1.2/50 μs
Insulation System Classification Protective Class II
Electro Magnetic Compatibility
Electrostatic discharges
Contact discharge 8kV
Air discharge 16kV
Electromagnetic RF fields
27MHz to 500MHz typical 10V/m
100kHz to 1GHz typical 30V/m
Fast transient burst test 4kV
Mechanical requirements
Meter shell Protection Rate IP54
Insulation System Classification Protective Class II
Maximum cable size 8 mm

Leave Your Message